Sgsk Reverse Mounting Strap [Set]  ...Ships Free when purchased concurrently with Sgsk 700 Trainer.

Polyester 1 in. wide strap [set] with buckles, precisely designed and customized for use with ^theShootingstreak^® Personal Free Throw Trainer.  For reverse mounting of the Trainer on the backside of the backboard.

To Install:  In the purchasing case where Reverse Mounting Strap (RMS) module ships separately from Trainer or is not already in place, the RMS [set] may require mounting on the Lower Vertical Arms (LVAs).  In such case, the procedure is to...

stand the Support Assembly (SA) upright and manually press in the detente buttons to release and slide the telescoping Upper Vertical Arm (UVAs), and then the rubber cushioning sleeves, off of the LVAs; then, slip RMS loop ends over LVAs – slipping loop end of [female] buckle strap piece over left lower arm and loop end of [male] prong strap piece over right lower arm (or conversely, if you're left handed) – then replace sleeves and UVAs.  Once so installed, RMS can stay in place.

To Implement:  wrap Left strap (encircling) around, or at least over, rim plate near where it meets the backboard and then insert into its buckle the prongs of the other (Right) strap end and pull Right strap extension downward to cinch tight and insure a snug fit against bottom edge of backboard (see: SideShield™ Ball Baffle and Gallery, Video 4: Reverse Mounting).

To Dismount:  push in snap lock levers on side of buckle to release strap ends and unwrap strap from around rim plate. To demount the Trainer, continue with demounting procedure described on Mounting/Demounting page (»» Sidebar: 'Information').